DC MOTOR REMOTE CONTROL CW/CCW

All pictures are for illustrative purposes only.

PID# 1026

25,00 CA$
Free shipping: On orders over $120 within BC
Quantité

Request a large quantity quote

Description

Note: this does not come with the battery nor the motor

This is a very small micro-motor motor forward and reverse controller. The input DC3V-12V output DC3V-12V controls the exchange of the positive and negative poles of the output terminal. The voltage between the wide voltage DC3V-12V can be used. The MOS non-contact silent receiver, The extremely small size is 21mm*11mm*5mm, and the ultra-low power consumption standby current is only 0.05mA. It is suitable for battery-powered motors, especially small battery-powered door locks.

 

Working voltage: DC3V-12V

(The voltage between wide voltage DC3V-12V can be used, 3.3V 3.6V 3.7V 4.5V 5V 6V 7.4V 9V 12V can be used)

Working current: 6ma mA

Standby current: 0.5ma mA

 

(Ultra-low standby current, suitable for battery power supply, it will automatically switch to a low-power sleep state during standby, it is recommended to press the remote control button for more than 0.5 seconds )

 

Maximum load: 0.4A (400ma mA) Recommended load is less than 0.2A (200ma mA)

 

(The receiver itself has overcurrent protection. When the current exceeds the rated current, it will power off protection. For example, when the motor starts or the locked rotor current is doubled, it will flash if it exceeds the rated current.)

 

Working frequency: 433.92MHZ

 

Size : 21*11*5mm

 

Interlocking-------3 keys, press the up key to run forward, press the stop key to stop, press the key to reverse, press the stop key to stop  

                , press the up key to run forward and press the key to reverse when the 2 key is pressed (there is no stop key, remote control cannot be stopped)

 

Jog-----Press and hold the up button to rotate forward, let go to stop, press and hold the down button to reverse, let go to stop

 

Jog delay 5 seconds----press and hold the up button to rotate forward, stop after 5 seconds after letting go, press and hold the down button to reverse, and stop after 5 seconds after letting go,

 

Jog for 1 second-----press and hold the up button to rotate forward for 1 second, and automatically stop, press and hold the down button to reverse for 1 second, and automatically stop

 

Jog for 3 seconds ---- press and hold the up button for 3 seconds to rotate forward, automatically stop, press and hold the down button for 3 seconds to reverse, and automatically stop

 

 

Very small motor motor forward and reverse controller, the voltage and current of the motor are passed through the receiver, please measure the exact voltage and current of your own motor

Related products