ARDUINO 9 AXES MOTION SHIELD
All pictures are for illustrative purposes only.
  • ARDUINO 9 AXES MOTION SHIELD

ARDUINO 9 AXIS MOTION SHIELD

15502
CA$55.00

The Arduino 9 Axes Motion Shield is based on the BNO055 absolute orientation sensor. The BNO055 is a System in Package (SiP), integrating a triaxial 14-bit accelerometer, a triaxial 16-bit gyroscope with a range of ±2000 degrees per second, a triaxial geomagnetic sensor and a 32-bit microcontroller running the BSX3.0 FusionLib software.

OUT OF STOCK Quantity


The Arduino 9 Axes Motion Shield is based on the BNO055 absolute orientation sensor. The BNO055 is a System in Package (SiP), integrating a triaxial 14-bit accelerometer, a triaxial 16-bit gyroscope with a range of ±2000 degrees per second, a triaxial geomagnetic sensor and a 32-bit microcontroller running the BSX3.0 FusionLib software. The sensor features three-dimensional acceleration, yaw rate and magnetic field strength data each in 3 perpendicular axes. It also provides the sensor fusion signals such as Quaternion, Euler angles,Rotation vector, Linear acceleration and gravity vector.

Arduino 9 Axes Motion Shield- Click to Enlarge

In addition, it incorporates an intelligent interrupt engine, which allows for triggering interrupts based on slow or no motion recognition, any motion (slope) detection and high-g-detection.The shield is TinkerKit compatible, which means you can quickly create projects by plugging TinkerKit modules to the board.

Power:
The Arduino 9 Axes Motion Shield has no power jack and is powered only when attached to an Arduino board.

Input and output: 
The shield features several TinkerKit input/output and communication interfaces. Connecting TinkerKit modules can simplify the creation of a project or a prototype.

Physical characteristics: 
The maximum length and width of the 9 Axes Motion Shield PCB are 2.7 and 2.1 inches respectively. Four screw holes allow the board to be attached to a surface or case. Note that the distance between digital pins 7 and 8 is 160 mil (0.16"), not an even multiple of the 100 mil spacing of the other pins.

Compatibility:
The Arduino 9 Axes Motion Shield is compatible with Uno, Yùn, Leonardo, Ethernet, Mega and Due boards. When using the Arduino 9 Axes Motion Shield, be sure to solder the Interrupt bridge and Reset bridge in the correct position depending on the board used.

Programming:
The 9 Axes Motion Shield can be programmed with the Arduino software.

9 Axes Motion Shield Configuration

The board has two solder jumpers for configuration of the Interrupt Pin and Reset Pin. The Reset Pin comes pre-set to D4 as that is used for all compatible official Arduino boards. However, you will have to make a solder connection on the INT jumper to select the correct Interrupt pin for the Arduino host board you're using. Refer to the table below:

BoardINT PinRESET Pin
Arduino Uno D2 D4
Arduino Leonardo D7 D4
Arduino Yun D7 D4
Arduino Ethernet D2 D4
Arduino Due D2 D4
Arduino Mega D2 D4