• New
All pictures are for illustrative purposes only.

BLUETOOTH SPEAKER /W ALARM CLOCK, BLACK, FM, MICRO USB, H8

18303
CA$30.00

BLUETOOTH SPEAKER /W ALARM CLOCK, BLACK, FM, MICRO USB, H8

LOW STOCK Quantity

H8 Bluetooth Speaker Manual:

Button Label Functionality
+ Increase Volume
- Decrease Volume
Power Button Turn on, off (put device on standby mode*)
M Changing speaker input mode
Reverse Reverse track or tune to previous programmed FM station*
Forward Forward track or tune to next programmed FM station*

*Please see detailed description below.

Regular Operation:

  • To enter standby mode, turn on the speaker and turn hold the power button for ~2 seconds.
  • To turn on the speaker, hold the power button until the device turns on; the default mode is on bluetooth (BLUE) mode.
  • Press the "M" button to cycle through different mode.
  • To change time: Turn on the speaker, and press the power button ~3 seconds until the device is on standby mode (labelled "OFF"). Press (do not hold) the power button once. Use +/- to change the time, and |< / >| button to change hour or minute. Press the power button once when finished.
  • To set up alarm clock: Enter to change time mode, and keep pressing >| Button until it says AL1, then set to the desired time. To turn on/off that alarm, press >| button again until it says "OFF" or "ON". Pressing >| again after will let you to select the alarm ringtone.
  • When the alarm is ringing, only the power button turns the alarm off, all other buttons will snooze the alarm and will repeat every 10 minutes. Each ring will last 1 minute.

Bluetooth Mode:

  1. The speaker (if unpaired) will automatically be discoverable by devices -- this is highlighted by blinking BT light. If the BT light is solid, it means that the speaker has been paired with another device.
  2. To unpair the speaker, perform the unpairing via your device (e.g.: phone, or laptop) by accessing the bluetooth connectivity and unpair the speaker.

FM Radio Mode:

  1. Attach the included antenna into the AUX 3.5mm port.
  2. Turn on the speaker and press M until it enters FM mode (Usually labelled by the FM frequency number).
  3. Press and hold the M button to automatically scan for available channels.
  4. Once the channels are stored, press >| or |< to select the desired channel.