ARDUINO 4 RELAY WITH I/O SHIELD

ARDUINO 4 RELAY WITH I/O SHIELD
All pictures are for illustrative purposes only.

PID# 16796

CA$16.00
Free shipping: On orders over $120 within BC

8 In Stock

Order now, processed next business day

Quantity

Request a large quantity quote

Description

Features

  • Arudino Uno/Leonardo compatible; Other board or microcontroller via jumper cables
  • Interface via digital I/O pins 4,5,6, and 7
  • Relay screw terminals
  • Standardized shield shape and design
  • LED working status indicators for each relay
  • High quality relays
  • COM, NO (Normally Open), and NC (Normally Closed) relay pins for each relay

Specification

Project

Min

Typical

Max

Unit

Supply Voltage

4.75

5

5.5

V

Power consumption (@ 5V)

180

mA

Opening and closing times per minute

30

Frequency

Maximum switching voltage per channel

125VAC/24VDC

Maximum switching current per channel

3

A

Dimension 

69X54X23

mm

Net Weight 

43

g

    

NOTE: Place 2 layers of electrical tape on the top of the Arduino's usb connector. This will prevent the relay shield from making contact. Do not operate voltage more than 35V DC.

Shield Interface Description

Relay Shield V2.0 terminal connections description

  • Digital 4 – controls RELAY4’s COM4 pin (located in J4)
  • Digital 5 – controls RELAY3’s COM3 pin (located in J3)
  • Digital 6 – controls RELAY2’s COM2 pin (located in J2)
  • Digital 7 – controls RELAY1’s COM1 pin (located in J1)

J1 Interface/Terminal Pin Description:

  • COM1 (Common Pin) : The relay pin controlled from the digital pin.
  • NC1 (Normally Closed): This terminal will be connected to COM1 when the RELAY1 control pin (Digital 7 I/O pin) is set low and disconnected when the RELAY1 control pin is set high.
  • NO1 (Normally Open): This terminal will be connected to COM1 when the RELAY1 control pin (Digital 7 I/O pin) is set high and disconnected when the RELAY1 control pin is set low.

Terminals J2-4 are similar to J1 except that they control RELAY2-RELAY4 respectively. 

Note: Only four Arduino Digital I/O pins, pins 4-7, are required to control the four different relays. Additionally the 5V and two GND Arduino pins are also required to power up the Relay Shield.