ARDUINO 9 AXIS MOTION SHIELD
The Arduino 9 Axes Motion Shield is based on the BNO055 absolute orientation sensor. The BNO055 is a System in Package (SiP), integrating a triaxial 14-bit accelerometer, a triaxial 16-bit gyroscope with a range of ±2000 degrees per second, a triaxial geomagnetic sensor and a 32-bit microcontroller running the BSX3.0 FusionLib software.
The Arduino 9 Axes Motion Shield is based on the BNO055 absolute orientation sensor. The BNO055 is a System in Package (SiP), integrating a triaxial 14-bit accelerometer, a triaxial 16-bit gyroscope with a range of ±2000 degrees per second, a triaxial geomagnetic sensor and a 32-bit microcontroller running the BSX3.0 FusionLib software. The sensor features three-dimensional acceleration, yaw rate and magnetic field strength data each in 3 perpendicular axes. It also provides the sensor fusion signals such as Quaternion, Euler angles,Rotation vector, Linear acceleration and gravity vector.
In addition, it incorporates an intelligent interrupt engine, which allows for triggering interrupts based on slow or no motion recognition, any motion (slope) detection and high-g-detection.The shield is TinkerKit compatible, which means you can quickly create projects by plugging TinkerKit modules to the board.
The Arduino 9 Axes Motion Shield has no power jack and is powered only when attached to an Arduino board.
Input and output:
The shield features several TinkerKit input/output and communication interfaces. Connecting TinkerKit modules can simplify the creation of a project or a prototype.
The maximum length and width of the 9 Axes Motion Shield PCB are 2.7 and 2.1 inches respectively. Four screw holes allow the board to be attached to a surface or case. Note that the distance between digital pins 7 and 8 is 160 mil (0.16"), not an even multiple of the 100 mil spacing of the other pins.
The Arduino 9 Axes Motion Shield is compatible with Uno, Yùn, Leonardo, Ethernet, Mega and Due boards. When using the Arduino 9 Axes Motion Shield, be sure to solder the Interrupt bridge and Reset bridge in the correct position depending on the board used.
The 9 Axes Motion Shield can be programmed with the Arduino software.
9 Axes Motion Shield Configuration
The board has two solder jumpers for configuration of the Interrupt Pin and Reset Pin. The Reset Pin comes pre-set to D4 as that is used for all compatible official Arduino boards. However, you will have to make a solder connection on the INT jumper to select the correct Interrupt pin for the Arduino host board you're using. Refer to the table below:
|Board||INT Pin||RESET Pin|
Product ID: 15401
Product ID: 15138
Product ID: 111171
Product ID: 15804
Product ID: 15100
Product ID: 2009
Product ID: 10357
Product ID: 10837
Product ID: 151562
Product ID: 15383